![]() ![]() Your drivers side module install is the same as what you have just accomplished, with one minor change.Module can be tucked into various positions behind the tail lens. Re-connect any loose light sockets to lens and be sure to tape all connections very well.Attach the remaining blue wire from the module to the two red/white wires coming out of harness.Attach the red wire from the module to the wire still attached to 元. Cut the red/white wire attached to the 元 socket.Attach the orange wire from the module to the wire still attached to L2. Cut the red/white wire attached to L2 socket.Attach one of the blue wires, does not matter which one, from the tail light module to the green with yellow strip wire coming from the new socket in the MAJOR cavity.Attach the brown wire coming from the new socket that is in the MINOR cavity to the green wire coming out of the wiring harness.Attach the two black wires coming from the wiring harness that you just cut the black wire coming from the new socket that is in the GRD cavity and the black wire coming from the tail light module all together.You are going to attach the supplied socket to the harness in place of this one. Remove the socket labeled L1, cut all three wires attached to it as close to the socket as you can. Notice we have the sockets labeled L1,L2 and 元.Be sure to squeeze rubber grommet through hole so that it will come with assembly. Remove the 3 nuts holding the tail light assemply on, then gently pull the assembly away from the car. Unplug the taillight harness connector from inside the car.To remove push pins, use your screw driver to pop up the center cap. Open your trunk and remove the rear tail light carpet/cover by loosening the 2 thumb screws and removing all 4 push pins. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |